AC CDI for a 125cc and 150cc GY6 engine
This is a 12 volt 5 watt and 21 watt dual element light bulb that is used in many of the tail lights for the Chinese made ATVs and dual sport dirt bikes.
Regulator - 4 wire with large female end
Regulator - 5 wire with large female end
Rectifier/Regulator - 6 wire with two 3 prong plugs
This CDI is for the 50cc and 125cc GY6 engine used in many 'made in China' scooters.
GY6 engine coil - Hi Tension wire about 14 inches long
GY6 engine coil - Hi Tension wire about 17 inches long
Ignition switch with 3 wires, and 2 keys.
12 volt 5 watt small light.
Master Cylinder, Rear Brake w reservoir - ATV and dirt bike
CG 175cc Cylinder Kit - 61.9mm - Loncin
PZ30 Carburetor - for 250cc Engines (Keihin)
150cc to 250cc Electric Starter - 11 spline, low mount
Carburetor - PZ19 with Cable Choke - Keihin
Rear brake master cylinder with reservoir for your Chinese made ATV or dirt bike.
Loncin cylinder kit for the 175cc (175cm³) CG style engine; 61.3mm piston - Includes; Piston, rings, wrist pin, cir-clips, cylinder, head gasket, and base gasket.
This is a Japanese designed (Keihin) PZ-30 carburetor with cable choke lever.
This 11 spline, low mount, starter fits many of the 150cc to 250cc vertical mount engines from China.
This Keihin PZ19 style carburetor will fit for 50cc, 70cc, 90cc, 100cc, 110cc or 125cc horizontal China made Honda Clone engines.
110cc Head and Base Gaskets
50cc to 110cc Electric Starter - Lower Mount
Brake Caliper for Pocket Bikes
Electric Starter Motor for the Jianshe 400ATV
Seal Set - 50cc GY6
These gaskets fits the head and cylinder on the 110cc (Honda Clone) horizontal engines from China.
This is a starter that mounts on the bottom of the engine.
This is a caliper with brake pads for a pocket bike or mini dirt bike.
Electric starter motor made by Jianshe in China for their 400cc utility ATV.
An oil seal set for a 50cc GY6 engine