Chinese made ATV brake assembly with front lever and rear foot master cylinders along with 2 front plus 1 rear calipers.
Chinese made ATV brake assembly with a rear foot master cylinder and 2 front plus 1 rear calipers.
Brake shoes for some electric bikes/scooters, small ATV's, and dirt bikes.
Chinese made ATV brake pads with two holes on one pad 68mm on center.
These rectangular shaped brake pads fit many 150cc and 200cc Chinese made ATVs plus they fit the Baja and Hsun 400cc front brakes.
This throttle assembly is for the right side of the handle bar and is the throttle and front drum brake lever.
Bolt for brake lever on a hydraulic brake system.
Rear brake calliper (this is caliper and pads) - one piston on each side
This left hand 6" brake lever is for the small ATVs
Brake Lever - Right - 7 1/2 inch for large ATV - with locking arm
Master Cylinder, Rear Brake w reservoir - ATV and dirt bike
CG 175cc Cylinder Kit - 61.9mm - Loncin
PZ30 Carburetor - for 250cc Engines (Keihin)
150cc to 250cc Electric Starter - 11 spline, low mount
Carburetor - PZ19 with Cable Choke - Keihin
Rear brake master cylinder with reservoir for your Chinese made ATV or dirt bike.
Loncin cylinder kit for the 175cc (175cm³) CG style engine; 61.3mm piston - Includes; Piston, rings, wrist pin, cir-clips, cylinder, head gasket, and base gasket.
This is a Japanese designed (Keihin) PZ-30 carburetor with cable choke lever.
This 11 spline, low mount, starter fits many of the 150cc to 250cc vertical mount engines from China.
This Keihin PZ19 style carburetor will fit for 50cc, 70cc, 90cc, 100cc, 110cc or 125cc horizontal China made Honda Clone engines.
140cc Head Gasket
Anodized Aluminum Gas Cap
Front Left Master Cylinder
Nut, M12 - Galvanized, nylock
This gasket fits the head on the 140cc (Honda Clone) horizontal engines from China.
Billet aluminum Gas cap for your Chinese pit bike
This a galvanized M8x40 bolt 1.25 mm/thread.
Front left master cylinder with site glass for ATVs (no lever)
This a galvanized M12 nut, 1.25 mm/thread